If you are a keen DIY’er or have done any plumbing in the past then you should be fairly confident when it comes to changing a tap, but if You’ve never done any plumbing before and are new to DIY, this type of job may seem like a step too far.

If you feel that you are closer to the latter, don’t fear, with a little guidance and thought, you should be able to easily complete a task such as this.

What Type of Tap do I Have?

Before we set about changing our taps, the first task is to establish exactly what sort of tap you have.

In essence, there are basically 3 different types:

  • The Pillar Tap: Probably the most common type of tap available. Commonly found on most baths and bathroom sinks, the pillar tap is an individual supply tap, supplying either hot or cold water
  • Standard pillar tap

  • The Mixer Tap: The mixer tap is most often found attached to the kitchen sink. It features two individual units, one hot and the other cold, and delivers both through a single spout
  • Mixer tap

  • The Monobloc Tap: This type of tap is a bit of an evolution on the mixer tap. As opposed to two individual units supplying through a single spout, the Monobloc is a small, single unit (not un-similar to an individual pillar tap) but both hot and cold are supplied through the single unit and only one lever controls both
  • Monobloc tap

Although each of the types of tap above look fairly different to each-other, essentially they are all fixed to the bath, basin etc and supplied with water in the same manner. With this in mind, the instructions below are universal and can be applied to any and all types of tap.

What You Need to Know to Successfully Change a Tap

Before you get busy with the spanners and disconnect your tap, the first job is to turn the water off so that you don’t inadvertently cause any floods.

If you are fortunate enough to have an isolation valve on the supply pipe to your tap you can turn it off here. If not, then you will need to locate your stopcock and turn the water off at the mains.

With the water now off, climb under the sink and loosen the tap connector on the base of the tap. This is what connects the tap to the water supply.

With the tap connector off, next, loosen and undo the backing nut that clamps the tap up to the sink.

Backing nut securing tap to basin

With this out of the way, you should now be able to lift your tap free of the sink. Give everything a good clean up around where the tap used to sit and you’re now good to fit your new tap.

When it comes to refitting, this is simply just a reverse of the removal steps above, just make sure you have tightened everything nicely to prevent any leaks.

Changing a tap should not be seen as a scary job and with a little thought and care can be easily done by anyone. For a full and comprehensive run down of how to change a tap check out our DIY project tutorial here.



This page titled How to Easily Change Taps on Baths, Basins and Sinks and more fantastic content can be found at this website. It was originally published on 2019-01-22 12:15:43.